To what extent can an uncertainty calculation be general?

 It is argued that results of uncertainty calculations in chemical analysis should be taken into consideration with some caution owing to their limited generality. The issue of the uncertainty in uncertainty estimation is discussed in two aspects. The first is due to the differences between procedure-oriented and result-oriented uncertainty assessments, and the second is due to the differences between the theoretical calculation of uncertainty and its quantication using the validation (experimental) data. It is shown that the uncertainty calculation for instrumental analytical methods using a regression calibration curve is result-oriented and meaningful only until the next calibration. A scheme for evaluation of the uncertainty in uncertainty calculation by statistical analysis of experimental data is given and illustrated with examples from the author's practice. Some recommendations for the design of corresponding experiments are formulated.     

Vanadium Doped Sol-Gel TiO2 Coatings

A study of the experimental conditions required to obtain vanadium doped sol-gel TiO2 coatings is presented. Tetraethyl orthotitanate was employed as the TiO2 source and VCl3, VOSO4 · H2O and VOSO4 dissolved H2SO4 where employed as vanadium sources.Dip coating has been used to produce coatings on silicon wafers, spectral carbon electrodes and titanium electrodes. Both supported and unsupported films have been studied by UV-Vis spectra, IR spectroscopy and X-ray diffraction (XRD). The measurements have been made on samples as prepared and treated thermally at temperatures between 100°C and 300°C. The thermal treatment temperatures have been established from DTA/TGA measurements.The vanadium doped sol-gel TiO2 coatings have been tested as sensors for redox potential measurements in electrochemical processes. The influence of both the thickness of films and the nature of substrate has been investigated.     

Br+CH3S(O)CH3反应机理的直接动力学研究

采用直接动力学的方法，对多通道反应体系Br＋CH3S（O）CH3进行了理论研究．在BH＆H-LYP／6-311G（2d，2p）水平下获得了优化几何构型、频率及最小能量路径（MEP），能量信息的进一步确认在MC-QCISD（单点）水平下完成．利用正则变分过渡态理论，结合小曲率隧道效应校正（CVT／SCT）方法计算了该反应的两个可行的反应通道在200K～2000K温度范围内的速率常数．在整个反应区间内，生成HBr的反应通道与生成CHa的反应通道存在着竞争，前者是主反应通道，后者是次反应通道．变分效应和小曲率隧道效应对反应速率常数的计算影响都很小．理论计算得到的两个反应通道的反应速率常数与实验值符合得很好．     

用热聚法固定指示剂的光纤氧气传感器研究

采用热聚法将甲叉双丙烯酰胺（MBBA）聚合并共价交联在硅烷化的玻璃微珠上 ，同时将指示剂Ru（Ⅱ）-邻啡咯啉配合物物理包埋于聚合物中，研制了一种基于 荧光猝灭原理的光纤氧气传感器，采用NaHSO_3-O_2-MnSO_4体系引发MBBA水溶液热 聚合后应，通过确定NaHSO_3,MnSO_4,MBBA和Ru(phen)_3Cl_2的最佳反应浓度以及 玻璃微珠的尺寸，优化了聚合反应条件，改善了指示剂的固定效果，制备了性能较 好的传感器探头，该传感器的检测下限为5×10~(-6)(V/V)，响应时间为10s该传感 器连续工作50min,重复性标准偏差为±1%。     

PTh / ZnO复合纳米粉的固相合成及其光谱特性

0引言导电聚合物/无机物纳米复合材料具有纳米材料和导电聚合物的共同特性,因此在电催化、二次充电电池材料、超级电容器材料等方面具有良好的应用前景[1]。聚噻吩(PTh)以及取代聚噻吩是导电聚合物领域中较早发现的具有环境稳定性和可加工性的材料之一。近年来,有关聚噻吩/无机物纳米复合材料的制备及其光电性能的研究倍受关注,Gebeyehu等[2]用PTh敏化纳米晶TiO2光伏电池,发现其光伏效率明显优于固态光伏电池;Jayant等[3]研究了PTh中的羧基基团的影响以及在纳米晶TiO2     

聚酰胺修饰碳糊电极测定槲皮素的研究

用聚酰胺修饰碳糊电极在ｐＨ３６０的Ｂｒｉｔｏｎ－Ｒｏｂｉｎｓｏｎ缓冲溶液中，将槲皮素开路富集一定时间后，从０４５Ｖ（ｖｓ．Ａｇ／ＡｇＣｌ）向阴极化扫描至－０５５Ｖ获得Ｉ－Ｅ曲线。槲皮素的峰电位为０１８Ｖ。峰电流与槲皮素浓度在１０～４００μｍｏｌ／Ｌ范围内呈良好的线性关系。所拟定方法用于芦丁水解产物测定，结果满意。     

三组分(NiO、La2O3、SiO2)负载型加氢催化剂中La2O3的作用

用X射线衍射分析、FT-IR、小角X光散射等方法研究了浸渍法制备的NiO/SiO_2和NiO/(La_2O_3+SiO_2)样品中组分之间的相互作用。La_2O_3在SiO_2上可形成近乎密置单层的分散。在负载了La_2O_3的SiO_2上,NiO的分散程度比在SiO_2上有明显提高,也更容易被还原,而且还原后所得金属镍粒子的平均粒度降低,小粒子所占百分比提高。这些结果表明,NiO/(La_2O_3+SiO_2)比NiO/SiO_2样品具有更高的加氢还原硝基普鲁卡因为胺基普鲁卡因的活性,与Ni/(La_2O_3+SiO_2)比Ni/SiO_2活性高的情形相一致。     

Synthesis and electrochemical properties of spinel LiMn2O4 prepared by the rheological phase method

Pure-phase and well-crystallized spinel LiMn₂O₄ powders were successfully synthesized by a simple rheological phase method. The thermal behavior and structure properties of the powders prepared by the rheological phase method compared with the solid-state reaction were investigated by thermogravimetry, powder X-ray diffraction , scanning electron microscopy and transmission electron microscopy. According to the results of the electrochemical tests, it is obvious that the sample resulting from the rheological phase method shows higher discharge capacity and better cycling stability than one formed in the solid-state reaction. The cyclic voltammogram and columbic efficiency curves also confirm that the product by the rheological phase method has a good cycling performance due to its fine cubic spinel structure and morphology.     

A statistical method to detect chromosomal regions with DNA copy number alterations using SNP-array-based CGH data

Single nucleotide polymorphism (SNP) arrays were used to detect chromosomal regions with DNA copy number alterations. Current statistical methods for microarray-based comparative genomic hybridization (array-CGH) analysis generally assume certain relationships among adjacent markers on the same chromosome, and these assumptions may be questionable. For an SNP-array-based CGH study, multiple normal reference SNP arrays were collected. In order to utilize these normal reference SNP arrays, we derived an empirical distribution of signal ratios for each SNP marker. With an assumed threshold value for the overall error rate control and the defined signal ratio ranges for chromosomal amplification and deletion, we proposed a procedure to identify chromosomal alteration regions based on several bootstrapped one-sample t-tests and the false discovery rate control. When we have multiple arrays for different individuals with the same disease, our method can also be used to detect SNP markers for chromosomal alteration regions that are common among these individuals. We applied our method to a published SNP array data set for breast carcinoma cell lines. For an individual with breast cancer, numerous chromosomal alteration regions were identified. Compared to results of previous studies, our method identified more chromosomal alteration regions, with some being implicated in the literature to harbor genes associated with breast cancer. For multiple cancer arrays, our results suggested the existence of common chromosomal alteration regions. However, a high proportion of false positives also indicated that genetic variations among different individuals with breast cancer can be present.     

溶剂对反胶束法合成CdS纳米粒子粒径的影响

以磺基琥珀酸二辛酯钠盐(AOT)为保护剂,利用反胶束法在不同烷烃溶液中合成了CdS纳米粒子.采用紫外-可见光谱、透射电子显微镜、荧光光谱法对其进行表征.研究表明:在不同烷烃溶液中合成的CdS纳米粒子,其粒子大小和荧光强度都随溶剂而改变.